Cisco Embedded Event Manager (EEM)

The Cisco Embedded Event Manager or Cisco EEM is a software component of Cisco IOS, IOS-XR, and NX-OS that provides real-time network event detection and onboard automation.

EEM allows you to automate tasks, perform minor enhancements and create workarounds and can makes life easier for network operators by tracking and classifying events that take place on a network device and providing actions options for those events.

Continue reading “Cisco Embedded Event Manager (EEM)”

Cisco Flexible Netflow configuration

Recently, a customer called me to configure Netflow on these routers because he just installed NetFlow Analyzer software from ManageEngine. This software is an “all in one” NetFlow collector, database, WebUI software, able to build pretty nice reports.

In my opinion, Netflow is one of the absolutely required software to have a good visibility when you operate a network. Continue reading “Cisco Flexible Netflow configuration”

Extending the LAN with a Meraki wireless mesh link

Cisco Meraki access-points can operate as mesh repeaters, which allows them to extend the wireless network range. Since repeaters also support wired clients plugged into their wired interface, a repeater can be used to bridge a remote LAN segment back to the main network.

This article explains how the LAN can be extended via a wireless bridge, including limitations and requirements. There are 3 supported designs for extending the LAN via wireless mesh. Continue reading “Extending the LAN with a Meraki wireless mesh link”

Building a LACP port-channel between Cisco and Huawei switch

Configuring a LACP link aggregation, EtherChannel, or port-channel, or Eth-trunk between Huawei and Cisco switch is something very common. But since the configuration syntax between the two vendors is different, it can be confusing.

In this article, I will show how to configure a LACP port-channel – called Eth-trunk on Huawei – properly between a Cisco catalyst switch running IOS or IOS-XE and a Huawei switch, model 6700 in this case.

Continue reading “Building a LACP port-channel between Cisco and Huawei switch”

Meraki mesh networking tests

Wireless mesh networking is included and enabled by default in every Cisco Meraki AP. The goal is to create a self-healing network that is resilient to cable and switch failures.

But, how does it works exactly?
How does an AP choose between the existing neighbors?
How can we monitor the status and performances of a mesh link?
And as it is enable by default, is it possible to deactivate this feature?

Continue reading “Meraki mesh networking tests”

How to add a switch to an existing Cisco C2960X stack without breaking everything

A Cisco C2960X stack can have up to 8 members, however there is only one master on the stack. Adding a switch to the stack without taking a few precautions can have disastrous consequences.

Continue reading “How to add a switch to an existing Cisco C2960X stack without breaking everything”

How to setup Cisco VIRL, VM Maestro to use SecureCRT as default terminal

The GUI application to use Cisco VIRL, VM Maestro, comes with a basic internal Telnet and SSH client called “Cisco Terminal”.

If, like me, you want to use the rock-solid SecureCRT as terminal emulator client, you need to change the the VM Maestro preferences. Continue reading “How to setup Cisco VIRL, VM Maestro to use SecureCRT as default terminal”